Calibrating the Noise in Your Qubit Readout Lines
Key points…
+ In most quantum labs, detecting the state of a qubit is done by sending and receiving weak microwave tones into a cryogenic refrigerator and strongly amplifying the output signal to boost the measurement fidelity as much as possible. At such small signal levels – even down to the limit of single photons – understanding and reducing noise added by the amplifier and other components becomes crucial.
In addition, the team also measured a new kind of amplifier that was made by NIST and Fermilab. They observed noise performance at the quantum limit using the new method – the results are presented in Applied Physics Letters in March 2021.
+ The development of the Cryogenic Variable-Temperature Noise Source supports world-leaders in quantum technology with their measurement challenges.
+ Senior Scientist Russell Lake and the Bluefors Quantum Team (including Aleksi Lintunen, Volodymyr Monarkha, and Slawomir Simbierowicz) developed the Cryogenic Variable-Temperature Noise Source to improve the speed and accuracy of validating qubit readout lines. The tool goes inside the cryogenic environment and adds controlled amounts of noise to the signal paths to calibrate the intrinsic noise added by the amplifiers, cables, and all other components
Source: BLUEFORS. BLUEFORS, Calibrating the Noise in Your Qubit Readout Lines…
Content may have been edited for style and clarity. The “+” to the left of paragraphs or other statements indicates quoted material from “Source:” document. Boldface title is original title from “Source:” Italicized statements are directly quoted from “Source:” document. Image sources are indicated as applicable.
